It’s possible that I shall make an ass of myself. But in that case one can always get out of it with a little dialectic. I have, of course, so worded my proposition as to be right either way (K.Marx, Letter to F.Engels on the Indian Mutiny)
Sunday, July 17, 2022
Canada's oilsands look into use of nuclear power as 'net zero changes everything'
CALGARY — The pressing global need to slash emissions in the face of a growing climate crisis is driving renewed interest in nuclear power — and few places more so than in Canada's oilsands.
Canada's oilsands l
While the idea of using nuclear power to replace the fossil fuels burned in oilsands production has been bandied about for years, some experts say the reality could be just a decade or so away. On paper, at least, there is more potential to deploy small modular reactor (SMR) technology in the oilsands region of Alberta than anywhere else in the country.
“Without a doubt the oilsands is the biggest market for small modular reactors in Canada," said John Gorman, president and chief executive of the Canadian Nuclear Association. "It's something that some companies are very actively looking at."
Small modular reactors are a type of nuclear design that is far smaller than a traditional nuclear reactor. Generating between 10 and 300 MW of energy, SMRs are fully scalable and are designed to be built economically in factory conditions, rather than on site like a large-scale conventional reactor.
While SMRs are not yet commercially available, the technology is getting close. The International Atomic Energy Agency estimates that nearly 100 SMRs could be operating around the world by 2030. In Canada, four provinces — New Brunswick, Ontario, Saskatchewan and Alberta — have agreed to collaborate on the advancement of SMRs as a clean energy option, and Canadian researchers are working on new materials and designs that could make SMRs practical in a large range of new uses.
Proponents say SMRs could potentially be used not only to provide clean electricity to smaller electricity grids, like those in rural areas, but also to provide heat for natural resource industries. In the oilsands, operators use massive amounts of high-temperature heat to produce the steam needed to extract bitumen from sand — and they get that heat by burning natural gas.
In total, the oil and gas industry is responsible for 30 per cent of Canada's natural gas consumption, which means confronting the industry's fossil fuel usage will be key if Canada is to meet its climate commitments.
The oilsands industry itself — through an organization called Pathways Alliance, which is made up of Canadian Natural Resources Ltd., Cenovus Energy Inc., ConocoPhillips Canada, Imperial Oil Ltd., MEG Energy Corp. and Suncor Energy Inc. — has committed to reducing greenhouse gas emissions from oilsands production by 22 million tonnes annually by 2030, and reaching a goal of net-zero emissions by 2050.
To help get there, the Pathways Alliance has proposed a major carbon capture and storage transportation line that would capture CO2 from oilsands facilities and transport it to a storage facility near Cold Lake, Alta. That project alone could deliver about 10 million tonnes of emissions reductions per year and could be up and running by the end of the decade.
But Pathways has also formed a committee to formally explore nuclear as an alternative to natural gas in oilsands production.
"Absolutely, we are looking at SMRs as a low or no-emission source of the high temperature heat we need," said Martha Hall Findlay, chief climate officer for Suncor Energy Inc. "But it has to be economically viable. It has to make sense."
Findlay said the industry will need clarity around what level of government financial support, if any, will be available for SMRs. There are also questions around the regulatory process, given the energy sector's frustrating experience in recent years getting large-scale projects approved.
"It's Canada — it takes a really long time to build anything," she said. "But if we want to see implementation by 2030, or into the early 2030s, we have to be doing this stuff now. We have to be looking at it now."
Dan Wicklum, president and CEO of non-profit advisory group The Transition Accelerator and the former CEO of the Canadian Oilsands Innovation Alliance, said the energy industry has formally evaluated the nuclear opportunity in the past and discarded it, largely because of cost.
But he said the industry's new target of net-zero emissions "changes everything."
"We can no longer just do the things we were going to do to reduce emissions. Optionality has fallen off the table for us," Wicklum said. "In an emissions elimination paradigm, there's no question that nuclear is being taken very seriously."
However, Wicklum added that for any large-scale emissions reductions projects to get off the ground, governments and industry will have to come to an agreement about whose responsibility it is to pay for them.
"Industry is looking to the federal government to say, 'make it worth our while', he said. "They want more taxpayer dollars. They've essentially said there's not enough public support right now for them to act. And because of that, I think, the feasibility of SMRs — as well as carbon capture and storage, and so on — is completely in question."
This report by The Canadian Press was first published July 17, 2022.
Companies in this story: (TSX:TKTK)
Amanda Stephenson, The Canadian Press
Sunday, May 06, 2007
Alberta Tories Support Nuking the Tarsands
Nuclear power is for creating electrical energy, the use that is being looked at for the Tarsands is to produce steam for injection into the oilsands to release the bitumin, which is neither efficient nor cheap. Nuclear power to just produce steam is like hunting flies with a shotgun.
Also Saturday, delegates voted to explore using nuclear power plants to assist oilsands development.
Delegate Bill Dearborn of Medicine Hat said the oilsands need a nuclear option as a bulwark against any future federal raids on Alberta's resource-based economy.
"We're familiar with these Liberal governments in Ottawa that have imposed unfair taxes on the oil and gas industry in the past,'' he said.
But delegate Don Dabbs said he has participated in a past provincial study on nuclear power and that it's not the way to go to generate steam power for the oilsands.
"A reactor to generate steam is not the principal purpose of a nuclear reactor. It's for electrical energy.
"It's a very expensive source of steam.''
Thomas Savery (1650-1715)
Thomas Savery was an English military engineer and inventor who in 1698, patented the first crude steam engine, based on Denis Papin's Digester or pressure cooker of 1679.Thomas Savery had been working on solving the problem of pumping water out of coal mines, his machine consisted of a closed vessel filled with water into which steam under pressure was introduced. This forced the water upwards and out of the mine shaft. Then a cold water sprinkler was used to condense the steam. This created a vacuum which sucked more water out of the mine shaft through a bottom valve.
Boilers
The high-pressure steam for a steam engine comes from a boiler. The boiler's job is to apply heat to water to create steam. There are two approaches: fire tube and water tube.A fire-tube boiler was more common in the 1800s. It consists of a tank of water perforated with pipes. The hot gases from a coal or wood fire run through the pipes to heat the water in the tank, as shown here:
In a fire-tube boiler, the entire tank is under pressure, so if the tank bursts it creates a major explosion.
More common today are water-tube boilers, in which water runs through a rack of tubes that are positioned in the hot gases from the fire. The following simplified diagram shows you a typical layout for a water-tube boiler:
In a real boiler, things would be much more complicated because the goal of the boiler is to extract every possible bit of heat from the burning fuel to improve efficiency.
Pressurised Heavy Water Reactor (PHWR or CANDU).
The CANDU reactor design has been developed since the 1950s in Canada. It uses natural uranium (0.7% U-235) oxide as fuel, hence needs a more efficient moderator, in this case heavy water (D2O).**
** with the CANDU system, the moderator is enriched (ie water) rather than the fuel, - a cost trade-off.
The moderator is in a large tank called a calandria, penetrated by several hundred horizontal pressure tubes which form channels for the fuel, cooled by a flow of heavy water under high pressure in the primary cooling circuit, reaching 290ƒC. As in the PWR, the primary coolant generates steam in a secondary circuit to drive the turbines. The pressure tube design means that the reactor can be refuelled progressively without shutting down, by isolating individual pressure tubes from the cooling circuit.
A CANDU fuel assembly consists of a bundle of 37 half metre long fuel rods (ceramic fuel pellets in zircaloy tubes) plus a support structure, with 12 bundles lying end to end in a fuel channel. Control rods penetrate the calandria vertically, and a secondary shutdown system involves adding gadolinium to the moderator. The heavy water moderator circulating through the body of the calandria vessel also yields some heat (though this circuit is not shown on the diagram above).
Steam generator (nuclear power)
From Wikipedia, the free encyclopedia
- This is an article about nuclear power plant equipment. For other uses, see steam generator.
Steam generators are heat exchanger used to convert water into steam from heat produced in a nuclear reactor core. They are used in pressurized water reactors between the primary and secondary coolant loops.
In commercial power plants steam generators can measure up to 70 feet in height and weigh as much as 800 tons. Each steam generator can contain anywhere from 3,000 to 16,000 tubes, each about three-quarters of an inch in diameter. The coolant is pumped, at high pressure to prevent boiling, from the reactor coolant pump, through the nuclear reactor core, and through the tube side of the steam generators before returning to the pump. This is referred to as the primary loop. That water flowing through the steam generator boils water on the shell side to produce steam in the secondary loop that is delivered to the turbines to make electricity. The steam is subsequently condensed via cooled water from the tertiary loop and returned to the steam generator to be heated once again. The tertiary cooling water may be recirculated to cooling towers where it sheds waste heat before returning to condense more steam. Once through tertiary cooling may otherwise be provided by a river, lake, ocean. This primary, secondary, tertiary cooling scheme is the most common way to extract usable energy from a controlled nuclear reaction.
These loops also have an important safety role because they constitute one of the primary barriers between the radioactive and non-radioactive sides of the plant as the primary coolant becomes radioactive from its exposure to the core. For this reason, the integrity of the tubing is essential in minimizing the leakage of water between the two sides of the plant. There is the potential that if a tube bursts while a plant is operating; contaminated steam could escape directly to the secondary cooling loop. Thus during scheduled maintenance outages or shutdowns, some or all of the steam generator tubes are inspected by eddy-current testing.
In other types of reactors, such as the pressurised heavy water reactors of the CANDU design, the primary fluid is heavy water. Liquid metal cooled reactors such as the in Russian BN-600 reactor also use heat exchangers between primary metal coolant and at the secondary water coolant.
Boiling water reactors do not use steam generators, as steam is produced in the pressure vessel.
See:
Sustainable Capitalism
Tarsands To Go Nuclear
Nuke The Tar Sands
Dion Pro Nuke
Cutting Your Nose
EnergyCANDU
Peak Oil
Tar Sands
Find blog posts, photos, events and more off-site about:
Canada, Greenplan, Alberta, Saskatchewan, GaryLunn, JohnBaird, CleanCoal, hydro, nuclear, nuclear power, Ontario Power Workers Union, EPCOR, Utilities, Greenhouse gases, CO2, Conservatives, Government, eak-oil, Tarsands, water, Pembina, Klein, oil, nukes, nuclear, gas, water, drought, Alberta, Canada,AECL, candu, nuclear, nuclear-power, EnergyProbe, privatization, Conservatives, Flaherty, Munn, Government, Alberta, tarsands, nuke, nukes, power, energy,